To start the deployment process, press the Start deployment button.
The progress of each task is displayed in the Status column.
The total progress is displayed in a separate progress bar.
To stop the deployment, click Cancel. TSD will not perform the remaining tasks in queue, but the current deployment process will finish.
To cease the current deployment process, click Halt. It may not stop immediately though.
It's not necessary to monitor the deployment process. You can switch to another mode while deployment is being performed in background. The icon of the Deployment section will display the progress.
When the deployment is being performed, the following actions are prohibited: operations with the Storages (closing, reloading, removing software and computers), rerecording and editing the deployment packages engaged in the current deployment.
When the deployment is complete, you can see the result of each task in the main area.
If an error has occurred while performing the task, the information about the error will be displayed in the Status column.
To only display tasks with errors when the deployment is over, use the filter to the right of the deployment progress bar.
You can also save the currently displayed tasks to a new list of deployment targets for later use. To do so, click the save button to the right of the filter. The list of computers with errors can be saved automatically (you can enable this from Options - Deployment).
After a successful deployment, we recommend to rescan the computers to update the information about the installed software. To make this process automatic, enable Rescan target computers after deployment in Options - Deployment.
Back to editing closes the deployment results.
A tool to manage software deployment in your corporate network.